Compatible With All Capser Soft Tonneau Covers
Capser Tonneau Cover Replacement Velcro Kit
Replacement hook-and-loop strips that seal both sides of a Capser soft cover against the bed rail. Worn velcro is a common reason a cover starts to shift or gap along the sides after a few years of use.
Shop This KitOverview
Capser soft roll-up and tri-fold covers seal both sides with Velcro strips along the bed rail, working alongside the tailgate latch system to keep the top wrinkle-free and tight. Like any hook-and-loop material, it gradually loses grip strength after repeated opening, closing, and sun exposure. This kit gives you fresh strips sized to match the rail length on your specific cover.
Replacing worn velcro is a small, inexpensive fix for a top that’s started to shift or gap along the sides, without needing to touch the latches, seals, or the vinyl top itself.
What’s Included
Rail-Side Strips
Adhesive-backed hook strips sized to match the bed rail length on Capser soft covers.
Vinyl-Side Strips
Matching loop strips sized to attach to the underside of the vinyl top or panel.
Adhesive Backing
Both strip sets use a weatherproof adhesive backing for a clean, no-tools installation.
Install Guide
A printed installation guide walks through removing the old velcro and applying the new strips evenly.
Checking Compatibility
This kit is sized for the standard bed rail length used across the Capser soft roll-up and soft tri-fold cover lineup. Rail length varies by truck bed size, so check the model name on your original packaging or email us your truck and cover style and we’ll confirm the right kit before you order.
How Installation Works
- Remove the old velcro. Peel the worn strips off both the bed rail side and the underside of the vinyl top.
- Clean both surfaces. Wipe down the rail and vinyl underside so the new adhesive bonds properly.
- Apply the rail-side strip. Press the new hook strip evenly along the bed rail.
- Apply the vinyl-side strip. Press the matching loop strip onto the underside of the vinyl top.
- Test the seat. Close the cover and check that both sides sit snug and even along the full rail length.
Specifications
Why Replace Your Velcro
- Restores a snug, even side seal without replacing the whole cover
- Adhesive-backed strips install in under 25 minutes, no tools needed
- Sized to match the bed rail across the soft cover lineup
- Far less expensive than a full cover replacement
Frequently Asked Questions
How do I know if my velcro needs replacing?
If the vinyl top shifts, gaps along the side rail, or doesn’t sit as snug as it used to, worn hook-and-loop strips are usually the cause.
Does this work on hard tri-fold or quad-fold covers too?
This kit is sized for the Velcro side seal used on Capser soft roll-up and soft tri-fold covers. Hard covers and quad-fold covers use a different sealing approach — email us your cover model to confirm.
Do I need any tools to install it?
No. Both strip sets use an adhesive backing that presses directly onto the bed rail and vinyl underside — no drilling or special tools required.
How long does the new velcro last?
The hook-and-loop material typically holds up for several years of regular use before it needs replacing again.
Get a Snug Fit Again
A fresh velcro kit restores an even side seal in under 25 minutes.
Shop This Kit